Adding Laundry Products - Whirlpool WFC682CLW Owner's Manual

All-in-one washer & dryer
Hide thumbs Also See for WFC682CLW:
Table of Contents

Advertisement

Available languages

Available languages

ADDING LAUNDRY PRODUCTS

Adding HE detergent to basket:
Single-dose laundry packets, Oxi-
type boosters, color-safe bleach, or
scented crystals can be added to
the drum prior to adding laundry.
When using single-dose laundry
packets, make sure that the Load &
Go
Bulk Dispenser option is
disabled (on some models).
NOTE: Follow the manufacturer's instructions to determine the
amount of laundry products to use.
Adding liquid chlorine bleach to single-load dispenser:
Add liquid chlorine bleach to
the bleach compartment. Do
not overfill, dilute, or use more
than 2/3 cup (165 mL). Do not
use color-safe bleach or Oxi in
the same cycle with liquid
chlorine bleach.
IMPORTANT:
� Always measure liquid chlorine bleach. Use a measuring cup
with a pour spout; do not guess.
� Do not fill beyond the "MAX" line. Overfilling could cause
garment damage.
� Do not use thickened, easy-pour, or no-splash bleach when
running the Clean Washer with affresh
may occur.
� On some models: Do not add liquid chlorine bleach to the bulk
dispenser.
� Slowly close dispenser drawers. Make sure the drawers are
closed completely.
Adding liquid fabric softener to single-load dispenser:
Pour a measured amount of liquid
fabric softener into liquid fabric
softener compartment. Always
follow manufacturer's directions for
correct amount of fabric softener,
based on your load size. Disable
the 1 Liter Load & Go
dispenser if
not used to dispense detergent.
Fabric softener is always dispensed in the last rinse.
IMPORTANT: Do not overfill, dilute, or use more than the
manufacturer-recommended quantity of fabric softener. Do not fill
past the "MAX" line. Overfilling dispenser will cause fabric softener
to immediately dispense into machine.
� Do not spill or drip any fabric softener onto the clothes.
� Do not use liquid fabric softener dispenser balls in this
machine. They will not dispense correctly.
� Do not use fabric softener sheets, as they can stain the load.
Adding HE detergent to Load & Go
models):
Use only High Efficiency (HE) liquid detergents. The bulk
dispensers will hold about 67.6 oz. (2 L) or 33.8 oz. (1 L) of liquid
HE detergent, depending on dispenser, or enough for many loads
of laundry.
®
cycle, as excess suds
dispenser (on some
To fill bulk dispensers:
Open the dispenser drawer by pulling on the handle at the base of
the machine. If desired, the drawer can be completely removed
from the machine.
Locate the Load & Go
bulk dispenser. Gently
pull up on the tab located on the bulk dispenser
lid to lift the fill door.
Fill to the "MAX" line (see illustrations at right)
with HE liquid detergent or liquid fabric softener
(1-liter dispenser only). Close fill door. It will click
into place. Make sure the concentration setting
is correct (see the online "Cycle Guide").
It is recommended that you rinse out the Load &
Go
containers when refilling, when changing
detergent types or concentrations, or when the
will not be used for an extended period. For
instructions on cleaning the dispenser cartridge,
see "All-In-One Washer & Dryer Care" in the
"Maintenance and Care" section of your
Owner's Manual.
When you want the machine to use the Load & Go bulk
dispenser for automatic detergent dispensing, make sure that
the Load & Go
bulk dispenser option is enabled (on some
models). Also, do not add any detergent to the single-load
dispenser.
Adding HE detergent to single-load dispenser:
Pour a measured amount of HE
detergent into detergent
compartment. For powdered
detergent, lift the selector to the high
position. For liquid detergent, push
down the selector to the low position.
Do not overfill; adding too much detergent may cause detergent
to be dispensed into the machine too early.
When using single-dose dispenser for detergent, make sure that
the Load & Go
bulk dispenser option is disabled (on some
models).
Getting the most out of your All-In-One Washer & Dryer:
Your new machine is configured to run wash & dry cycles by
default. You also have the option to run Wash Only cycles or Dry
Only cycles. Refer to the Cycle Guide for additional details.
For optimal drying results and to avoid wrinkling of clothes, do
not load clothes more than half full. Since this unit uses a
ventless drying technology, expect longer dry times compared to
a vented dryer.
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents