Layer Setup - Korg modwave native Manual

Arp & Setup page
Trigger
Latch
[Off, On]
Off: The Arpeggiator will only play as long as notes are being held on the keyboard (or via the damper pedal).
On: The Arpeggiator will continue to play after notes are released.
Sync Notes
[Off, On]
Off: The arpeggiator starts immediately when the first note is played, and does not synchronize to any Motion
Sequences or itself when latched. You could use this if you were playing with a human drummer and needed to reset the
arpeggiator rhythm to the drummer's beat periodically.
On: The arpeggiator will synchronize to either sounding Motion Sequences or itself when latched. When synchronizing
to Motion Sequences, the first note will sound when played, but subsequent arpeggiator-generated notes will be in sync
with the Motion Sequence. When playing a latched arpeggiator, new notes will sound when the arpeggiator beat comes
around; the arpeggiator's rhythm is not disturbed by playing new notes.

Layer Setup

Volume
[-Inf, -84.9...+6.0 dB]
This controls the volume of the Layer. Note that this is saved in the Performance, but not with the Program—so it's a
good choice when balancing levels between Layers.
Pitch
These parameters control the octave and tuning of the Layer. As with Layer volume, this is saved in the Performance,
but not with the Program—so it's a good choice when creating detuning or octave offsets between Layers, without
making the Program play out of tune if it's saved and selected elsewhere!
Octave
[-3...+3]
This transposes the Layer by 3 octaves, up or down.
Tune
[-100...+100 cents]
This lets you detune the Layer by up to 100 cents (1/100 of a semitone), up or down.
MIDI
Use Global MIDI Channel
[Off, On]
On: This is the default. The Layer will receive on the Global Channel.
Off: The Layer will receive on the channel specified below.
MIDI Channel
[1...16]
This is shown only if Use Global MIDI Channel is Off. It sets the channel on which the Layer will receive MIDI.
Rx Damper
[Off, On]
On: This is the default. The Layer will respond to MIDI CC#64.
Off: The Layer will ignore MIDI CC#64.
49