Modulation List Page - Korg modwave native Manual

Modulation List page

2. Show In
Mod List
3. Mod
Sources
This page gathers together all of the modulation sources and modulation routings into a single screen. You can even
edit the original values of the modulated parameters, along with all of the modulation settings.
For general information on using modulation, see "Modulation" on page 13.
1. Show in Mod List
This section lets you filter the Mod List to show only the routings that you're interested in. There are three sections,
ordered from top to bottom, each of which filters the next.
The top section lets you select All modulations, only modulations at the Performance level (such as modulation of Mod
Knobs, Master Reverb, or Kaoss Physics), or modulations for the currently selected Layer.
The middle section filters by either destination category (such as Synth or Effects) or source category (such as
Controllers or Generators).
The bottom section more specifically, such as by specific synth section (such as the Filter) or a specific controller (such
as the Mod Wheel).
2. Mod List
This shows all of the modulation routings which match the criteria set in the Show in Mod List section. You can change
mod source selections, adjust modulation Intensities, delete modulation routings, and even edit the value of the
original parameter.
Note: built-in modulation routings, such as Filter Envelope modulation of Filter Cutoff or Amp LFO modulation of
Level, are not shown here.
3. Mod Knobs
The Mod Knobs are available here, along with all of the other Mod Sources in the footer at the bottom of the window.
4: Layer Select
These select which of the Layers is shown in Column 1 of the Show in Mod List section, as described above.
Modulation List page
1. Mod List
56