Restoring Keymoved Keys To Default Settings; Restoring A Single Keymoved Key; Restoring All Keymoved Keys In A Single Mode; Changing Volume Lock - One for All URC-8820 B00 User Manual

OFA 8L with Learning Owners Manual.fm Page 15 Monday, January 24, 2005 10:04 AM
Press and hold SET until the LED (red
2.
light) blinks twice, then release SET.
Enter 9 9 4. The LED will blink twice.
3.
4. Press the destination key twice (where
the keymoved key is stored). The LED
will blink twice.
Restoring All Keymoved Keys in a Single
Mode
Press and hold SET until the LED (red
1.
light) blinks twice, then release SET.
Enter 9 9 4. The LED will blink twice.
2.
3. Press the destination mode twice
(where keymoved keys are stored). The
LED will blink twice.

CHANGING VOLUME LOCK

The One For All 8L Universal Remote
Control with Learning (URC-8820 B00) is
set at the factory for independent volume
control of each selected device.
However, you may change the Volume Lock
setting to Global Volume Lock so that a
device's volume will be locked to one mode
(e.g., to control TV volume in all other
modes). After that, if desired, you can
perform Individual Volume Unlock on a
selected device to set its volume control for
independent operation.
L V C
OCKING OLUME ONTROL TO
(G V L )
LOBAL OLUME OCK
Press and hold SET until the LED (red
1.
light) blinks twice, then release SET.
Enter 9 9 3 and then press any mode
2.
key once (e.g., TV). The LED will blink
twice.
Now, when you press VOL +, VOL -, or
3.
MUTE, the volume of the selected
device (e.g., TV) will be controlled
regardless of the mode you have
selected.
U V
NLOCKING OLUME
S D
INGLE EVICE
U )
NLOCK
After performing Global Volume Lock
1.
(see left), press a desired mode key
where you want volume to be unlocked
(e.g., AUD) and controlled within its
own mode.
Press and hold SET until the LED (red
2.
light) blinks twice, then release SET.
Enter 9 9 3 and then press VOL - once.
3.
The LED will blink four times.
4. If desired, repeat steps 1 through 3 (of
this section) for each device that you
want volume to be unlocked.
5. Now, after you select a device that has
volume unlocked (e.g., AUD), pressing
VOL +, VOL -, or MUTE, will control the
device's volume only in its own mode.
U A
NLOCKING LL
(
R D
ESTORING
NOTE: Performing these instructions will
restore independent volume control for all
O M
NE ODE
programmed devices (e.g., TV volume
control in TV mode, VCR volume in VCR
mode, etc.).
1. On the remote control, press and hold
SET until the LED (red light) blinks
twice, then release SET.
Enter 9 9 3 and then press VOL + once.
2.
The LED will blink four times.
O ' M
WNER S ANUAL
C
ONTROL FOR A
(I V
NDIVIDUAL OLUME
V C
OLUME ONTROL
S )
EFAULT ETTING
Changing Volume Lock 15