Sena HelloDevice Pro PS110 Series User Manual page 52

AT&Tn [CR][LF]
AT or ATZ [CR][LF]
ATA/ [CR][LF]
ATA
[Local port number]
[CR][LF]
ATAR
[Local port number]
[CR][LF]
ATAS
[Local port number]
[CR][LF]
ATEn [CR][LF]
ATOn [CR][LF]
ATQn [CR][LF]
ATVn [CR][LF]
AT&Fn [CR][LF]
ATHn [CR][LF]
ATIn [CR][LF]
AT\Tn [CR][LF]
ATBn, ATCn, ATLn, ATMn,
ATNn, ATP, ATT, ATYn,
AT%Cn, AT%En, AT&Bn,
AT&Gn, AT&In, AT&Qn,
AT&V, ATMn, AT\An,
AT\Bn, AT\Nn, ATXn
ATS?, ATSn=x
Change and display the default data mode.
AT&T : Display the current Default data mode
AT&T0 : Change the Default data mode to Raw TCP mode
AT&T1 : Change the Default data mode to Telnet binary mode
Initialize TCP socket and serial port
Repeat last command
Set TCP mode as TCP server mode. And then, set TCP state
as [Listen].
-. If the command parameter, Local port number is not
specified, the TCP session parameter, Local Port is used
instead.
This command is similar to ATA. The difference is that ATAR
forces the connection to be Raw TCP connection regardless
of Cryptography configuration and Default Data mode option.
This command is similar to ATA. The difference is that ATAS
forces the connection to be SSLv3 connection. The
Cryptography configuration shoul d be SSLv3. If not, this
command returns ERROR.
E, E0: Disable echo
E1: Enable echo
O, O0: Turn to data mode
Q, Q0: Response display on (default)
Q1: Response display off
V, V0: Response = <numeric code> [CR][LF]
V1 (default): Response = <verbose code> [CR][LF]
F, F0, F1: Restore default modem settings
H, H0: Disconnect current TCP connection
All the data will be cleared
H1: Keep the current TCP connection
I, I0 : display "Sena Technologies, Inc."
I3 : display model number
Others : display "OK"
Set inactivity timer to n minutes
\T, \T0: inactivity timer disabled (default)
None
Internal S-register can be set or read.
Default values are shown on Table 4-4
Changed values are not preserved if the power is off.
52
AT&T
If Data mode=RawTCP
0 [CR][LF]
If Data mode=Telnet
binary
1 [CR][LF]
AT&Tn
If success,
OK[CR][LF]
If failure,
ERROR[CR][LF]
If success,
OK [CR][LF]
If failure,
ERROR [CR][LF]
<=
ERROR [CR][LF]
or
OK [CR][LF]
OK [CR][LF]
<=