Setup; Charging The Batteries - Sony Airpeak S1 Startup Manual

Setup

Charging the batteries

First charge the aircraft battery packs and built-in remote controller battery.
[1] Charging the aircraft battery packs
The battery level LEDs flash during charging and go off when the battery pack is fully charged.
The battery charger can hold two battery packs and will charge the second one after the first one is charged. Both
cannot be charged at the same time.
To check the battery level
You can check the battery level by pressing the battery level button on each battery pack.
Notes
• It may take about 20 sec. before charging begins. Wait until the battery level LEDs start flashing.
• A safety mechanism prevents charging when battery packs are hot or cold. Charging begins automatically once battery packs can be
charged at room temperature.
• If the difference between the remaining battery level in the two battery packs is 20% or more, the aircraft motor will not start.
[2] Charging the built-in remote controller battery
The battery level LEDs flash during charging and go off when the battery is fully charged.
Battery level LEDs
Battery level LEDs
17