Table of Contents
Advertisement
3
Charging instruction
3.1
Charging with one Dual Depot Charge Box
Start charging:
1.
Park the electric vehicle so that the charge inlet is located within reach of the
connector.
2. Turn off the electric vehicle.
3. Connect the charger's connector to the vehicle's charge inlet.
4. The charger will automatically start to charge the vehicle after completing the
preparation phase and will indicate the progress by the LED's state (see figure 3).
Stop charging:
5. The charge session will automatically stop after completing the bulk charge
mode (standard setting is 99% SOC for this setup but this can be customized).
6. The charge session can also be stopped manually by either pushing the stop
button on the Dual Depot Charge Box or the stop button on the bus (not
available on every bus).
7. Charging stops.
8. The connector is unlocked by the vehicle for CCS when the Dual Depot Charge
Box's beacon light changes color to green.
9. Take the connector out of the vehicle and put it back into the connector holder
on the Dual Depot Charge Box.
2 02 1- 0 6- 17
NOTICE
Session end
Charging will stop without user interaction:
When the EV indicates to the charger that charging is
complete.
When the charger completed the bulk charge.
If the battery is not full, a new charge session can be started.
NOTICE
Stop by emergency button
The charger stops the charge session when the emergency
stop is pushed. Push the emergency stop only in case of an
emergency!
DUA L D E P OT C HA RGE B OX
1 2 / 2 2
Advertisement
Table of Contents
