Table of Contents
Advertisement
PASSIVE ANTI-THEFT
SYSTEM
Principle of Operation
The system prevents someone from
starting the engine with an incorrectly
coded key.
Coded Keys
If you lose a key, you can obtain a
replacement from an authorized dealer. If
possible, provide them with the key
number from the tag provided with the
original keys. You can also obtain extra
keys from an authorized dealer.
Note: Have all of your remaining keys
erased and recoded if you lose a key. Have
replacement keys coded together with
recoding your remaining keys. See an
authorized dealer for further information.
Note: Do not shield your keys with metal
objects. This may prevent the receiver from
recognizing a coded key.
Arming the Engine Immobilizer
After you switch the ignition off the engine
immobilizer will arm automatically after a
short time.
Disarming the Engine Immobilizer
When you switch the ignition on the engine
immobilizer will disarm automatically if a
correctly coded key is used.
If you are unable to start the engine and
the message Key not detected is shown
in the display, the key has not been
recognized. Remove the key and try again.
If you are unable to start the engine with a
correctly coded key, and the message
Immobiliser malfunction Service now
is shown in the display, this indicates a
malfunction. Have your vehicle checked
by an authorized dealer immediately.
Fiesta (CC3) Indonesia/Philippines/Taiwan/Thailand/Vietnam, Vehicles Built From: 07-03-2016, CG3692en enPHI, Edition date: 201511, Second Printing
Security
ANTI-THEFT ALARM
Alarm System
The perimeter alarm is a deterrent against
unauthorized access to your vehicle
through the doors and the hood. It also
protects the audio unit.
Triggering the Alarm
Once armed, the alarm is triggered in any
of the following ways:
•
If someone opens a door, the liftgate
or the hood without a valid key or
remote control.
•
If someone removes the audio or
navigation system.
•
If you switch the ignition on without a
valid key.
If the alarm is triggered, the alarm horn will
sound for 30 seconds and the hazard
warning flasher will flash for five minutes.
Any further attempts to perform one of the
above will trigger the alarm again.
Arming the Alarm
To arm the alarm, lock your vehicle. See
Doors and Locks (page 33).
Disarming the Alarm
Vehicles Without Keyless Entry
Disarm and silence the alarm by unlocking
the doors with the key and switching the
ignition on with a correctly coded key or
unlocking the doors with the remote
control.
Vehicles with Keyless Entry
Note: A valid passive key must be located
within the detection range of that door for
keyless entry. See Keyless Entry (page 35).
38
Advertisement
Table of Contents
