Cruise Control; Principle Of Operation; Using Cruise Control - Ford FIESTA 2017 Owner's Manual

Hide thumbs Also See for FIESTA 2017:
Table of Contents

Advertisement

PRINCIPLE OF OPERATION

WARNING
The system does not relieve you of
your responsibility to drive with due
care and attention.
Cruise control allows you to control your
speed using the switches on the steering
wheel. You can use cruise control when
you exceed approximately 30 km/h.

USING CRUISE CONTROL

WARNINGS
Do not use cruise control on winding
roads, in heavy traffic or when the
road surface is slippery. This could
result in loss of vehicle control, serious
injury or death.
When you are going downhill, your
vehicle speed could increase above
the set speed. The system does not
apply the brakes.
E102679
The cruise controls are on the steering
wheel.
Note: Cruise control will disengage if your
vehicle speed decreases more than 16 km/h
below your set speed while driving uphill.
Fiesta (CC3) Indonesia/Philippines/Taiwan/Thailand/Vietnam, Vehicles Built From: 07-03-2016, CG3692en enPHI, Edition date: 201511, Second Printing

Cruise Control

102
(If Equipped)
Switching Cruise Control On
Press and release ON.
Setting the Cruise Speed
1.
Drive to desired speed.
2. Press and release SET+.
3. Take your foot off the accelerator
pedal.
The indicator displays in the
instrument cluster.
E71340
Changing the Set Speed
Press and release SET+ or SET- to
change the set speed in small
increments.
Press the accelerator or brake pedal
until you reach the desired speed. Press
and release SET+.
Press and hold SET+ or SET-. Release
the control when you reach the desired
speed.
Canceling the Set Speed
Press and release CAN, or tap the brake
pedal. The indicator no longer displays in
the instrument cluster. The set speed will
not be erased.
Note: For vehicles with manual
transmission, depressing the clutch pedal
will also cancel the set speed.
Resuming the Set Speed
Press and release RES. The indicator
displays in the instrument cluster.
Switching Cruise Control Off
Press and release OFF when the system is
in stand by mode or switch the ignition off.
Note: You erase the set speed when you
switch the system off.

Advertisement

Table of Contents
loading

Table of Contents