Bosch HDS8045C Installation Manual page 19

Insert the flat washer.
5.
Attach the red wire to the left junction block terminal
6.
using one of the hexagonal nuts.
Attach the white wire to the center junction block
7.
terminal using one of the hexagonal nuts.
Attach the black wire to the right junction block
8.
terminal using one of the hexagonal nuts.
Properly secure strain relief.
9.
WARNING
9
WARNING
The strain relief provided with your range cord
must be installed correctly.
Tighten all connections securely and replace terminal
10.
block cover.
Note: Do not plug in the range at this time.
Connecting the three-wire flexible conduit
The four-wire connection is preferred, but where local
codes and ordinances permit grounding through neutral
and/or conversion to four-wire is impractical, the unit can
be connected to the power supply via a three-wire
connection.
Disconnect the electrical power at the breaker box.
1.
Remove the terminal block cover to expose the
terminal block.
Insert the power supply cable into the terminal block
2.
through the bottom hole.
Insert the flat washer.
3.
Attach the red wire to the left junction block terminal
4.
using one of the hexagonal nuts.
Attach the white wire to the center junction block
5.
terminal using one of the hexagonal nuts.
Attach the black wire to the right junction block
6.
terminal using one of the hexagonal nuts.
Properly secure strain relief.
7.
WARNING
9
WARNING
The strain relief provided with your range cord
must be installed correctly.
Tighten all connections securely and replace terminal
8.
block cover.
Note: Do not plug in the range at this time.
19