MSI MS-7036 User Manual page 51

MS7036 M-ATX Mainboard
On-Chip Primary PCI IDE
The integrated peripheral controller contains an IDE interface with support for
two IDE channels. Choose [Enabled] to activate each channel separately. Settings:
[Enabled], [Disabled].
IDE Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-4) for
each of the four IDE devices that the onboard IDE interface supports. Modes 0
through 4 provide successively increased performance. In [Auto] mode, the
system automatically determines the best mode for each device. Setting options:
[Auto], [Mode 0], [Mode 1], [Mode 2], [Mode 3], [Mode 4].
Primary/Secondary Master/Slave Ultra DMA
Ultra DMA 33/66/100/133 implementation is possible only if your IDE hard drive
supports it and the operating environment includes a DMA driver (Windows ME,
XP or a third-party IDE bus master driver). If your hard drive and your system
software both support Ultra DMA/33, Ultra DMA/66, Ultra DMA/100 and Ultra
DMA/133, select [Auto] to enable BIOS support. Setting options: [Auto], [Disabled].
** On-Chip ATA Setting **
SATA Mode
This setting is used to set SATA mode. Setting options: [IDE], [RAID], [AHCI].
On-Chip Serial ATA
This setting is used to specify the SATA controller. The settings are:
[Disabled] Disable the SATA controller.
[Auto]
[Combined]
[Enhanced]
[SATA only]
PATA IDE Mode
This item is available for you to select the parallel ATA channel. Setting options:
[Primary], [Secondary].
SATA Port
This allows you to set the boot sequence of serial ATA port.
3-16
PATA and SATA will be arranged by BIOS, and you will be
able to see the IDE Device status listed in Standard COMS
Features.
PATA and SATA will be combined. Max. of 2 IDE drives in each
channel are available.
PATA and SATA will both be enabled. Max. of 6 IDE drives are
supported.
Only SATA is operating in legacy mode.