Table of Content 1. Introduction .......................... 2 2. Appearance ........................... 3 3. Main Feature ........................3 4. Set up Instruction ......................... 4 5. Data Report .......................... 5 5.1 Example of ReportDataCmd ..................6 5.2 Example of ConfigureCmd .................... 7 5.3 Example of calibration configuration ................9 6.
1. Introduction R718UBB all-in-one series is a ClassA type testing device based on LoRaWAN open protocol of Netvox, which can support multiple combinations of temperature and humidity, CO2, vibration, atmospheric pressure and illumination sensors, and is compatible with LoRaWAN protocol.
Low power consumption and long battery life Note: Battery life is determined by the sensor reporting frequency and other variables, please refer to http://www.netvox.com.tw/electric/electric_calc.html. On this website, users can find battery life time for varied models at different configurations.
4. Set up Instruction On/Off Power on Insert batteries. (users may need a screwdriver to open) Turn on Press and hold the function key for 3 seconds till the green indicator flashes once. Turn off (Restore to factory setting) Press and hold the function key for 5 seconds till green indicator flashes 20 times. Power off Remove Batteries.
If the CO2 value which customers test is inconsistent ,or there is large discrepancy of the primary standard, it can be recalibrated. For specific calibration methods,please refer to command 0x03 CalibrateType. Refer to Netvox LoRaWan Application Command documents and for data analysis reported by the device http://www.netvox.com.cn:8888/page/index...
Version– 1 byte –0x01——the Version of NetvoxLoRaWAN Application Command Version DeviceType– 1 byte – Device Type of Device The devicetype is listed in Netvox LoRaWAN Application Devicetype doc ReportType – 1 byte –the presentation of the NetvoxPayLoadData,according the devicetype NetvoxPayLoadData– Fixed bytes (Fixed =8bytes)
Device return:8300000000000000000000 6. Information about Battery Passivation Many of Netvox devices are powered by 3.6V ER14505 Li-SOCl2 (lithium-thionyl chloride) batteries that offer many advantages including low self-discharge rate and high energy density. However, primary lithium batteries like Li-SOCl2 batteries will form a passivation layer as a reaction between the lithium anode and thionyl chloride if they are in storage for a long time or if the storage temperature is too high.
Brand Load Resistance Activation Time Activation Current 165 Ω NHTONE 5 minutes 20mA 67 Ω RAMWAY 8 minutes 50mA 67 Ω 8 minutes 50mA 67 Ω SAFT 8 minutes 50mA Note: If you buy batteries from other than the above four manufacturers, then the battery activation time, activation current, and required load resistance shall be mainly subject to the announcement of each manufacturer.
8. Important Maintenance Instruction Kindly pay attention to the following in order to achieve the best maintenance of the product: • Keep the device dry. Rain, moisture and various liquids or water may contain minerals that can corrode electronic circuits. In case the device is wet, please dry it completely.