Installing Ddr2 Modules - MSI E7230 Master-FA4R User Manual

MS-9618 ATX Server Board
DIMM1 (Ch A) DIMM2 (Ch A)
256MB~1GB
256MB~1GB
256MB~1GB
256MB~1GB
256MB~1GB 256MB~1GB
MSI Reminds You...
- Dual-channel DDR2 works ONLY in the 5 combinations listed in
the table shown in the previous page.
- Please select the identical memory modules to install on the dual
channel, and DO NOT install three memory modules on three
DIMMs, or it may cause some failure.
- Always insert the memory modules into the Channel A slots first.
- Due to the South Bridge resource deployment, the system density
will only be detected up to 3+GB (not full 4GB) when each DIMM is
installed with an 1GB memory module.

Installing DDR2 Modules

1. The DDR2 DIMM has only one notch on the center of module. The module will
only fit in the right orientation.
2. Insert the DIMM memory module vertically into the DIMM slot. Then push it in
until the golden finger on the memory module is deeply inserted in the socket.
3. The plastic clip at each side of the DIMM slot will automatically close.
MSI Reminds You...
You can barely see the golden finger if the module is properly inserted
in the socket.
2-8
DIMM3 (Ch B) DIMM4 (Ch B)
256MB~1GB
256MB~1GB
256MB~1GB
256MB~1GB
256MB~1GB 256MB~1GB
Volt
Notch
System Density
512MB~2GB
512MB~2GB
512MB~2GB
512MB~2GB
1GB~4GB