Table of Contents
Advertisement
9.2
Drive system
The components of the drive system are
constantly checked automatically. If an error is
detected, an error message appears on the on-
board computer. The drive may be shut off
automatically, depending on the type of error.
9.2.1
Drive system or on-board computer
does not start up
If the display and/or the drive system do not start up,
proceed as follows:
1 Check whether the battery is switched on. If
not, start the battery.
Contact your specialist dealer if the battery
level indicator LEDs do not light up.
2 If the LEDs on the battery level indicator light
up, but the drive system does not start up,
remove the battery.
3 Insert the battery.
4 Start the drive system.
5 If the drive system won't start, remove the
battery.
6 Clean all the contacts with a soft cloth.
7 Insert the battery.
8 Start the drive system.
9 If the drive system does not start up, remove
the battery.
10 Charge battery fully.
11 Insert the battery.
12 Start the drive system.
13 Contact your specialist dealer if the drive
system does not start up.
MY23P01 - 22_1.0_21.10.2022
Troubleshooting, fault clearance and repair
9.2.2
Error message
If an error message is displayed, run through the
following actions:
1 Make a note of the system message. There is
a table containing all system messages in
Section
6.3.1.
2 Shut off and re-start the drive system.
3 If the system message is still displayed,
remove the battery and then re-insert.
4 Re-start the drive system.
5 If the system message is still displayed,
contact your specialist dealer.
206
Advertisement
Table of Contents
