Rechargeable Battery - Bosch 23-15-2055 Manual

Pegasus pedelecs with bosch purion on-board
Table of Contents

Advertisement

Code
Description
830
Error in the line to the
rear wheel speed
sensor
831
Implausible signals
833...
from the rear wheel
835
speed sensor.
Sensor disc may be
missing. It is defective
or incorrectly installed;
significantly different
tyre diameter between
the front wheel and
rear wheel; extreme
riding,
such as riding on the
rear wheel only
840
Internal ABS error
850
Internal ABS error
860,
Error in the power
861
supply
870,
Communication error
871,
880
883...
885
889
Internal ABS error
890
ABS indicator lamp is
defective or missing;
ABS may not be func-
tioning
No dis-
On-board computer
plays
internal error
Table 41: List of on-board computer error messages
MY23P01 - 22_1.0_21.10.2022
Method of resolution
 Contact specialist
dealer.
1
Re-start the system.
2
Take a test ride of at least
two minutes. The ABS
indicator lamp must go out.
3
Contact your specialist
dealer if the problem
persists.
 Contact specialist
dealer.
 Contact specialist
dealer.
1
Re-start the system.
2
Contact your specialist
dealer if the problem
persists.
1
Re-start the system.
2
Contact your specialist
dealer if the problem
persists.
 Contact specialist
dealer.
 Contact specialist
dealer.
 Re-start the drive system
by switching it on and off.
6.3.2

Rechargeable battery

The battery is protected against deep discharge,
overcharging, overheating and short circuits by
Electronic Cell Protection (ECP). In the event of a
hazard, a protective circuit switches the battery off
automatically. If a fault is detected in the battery,
the LEDs flash on the battery level indicator.
Description
Code:
If the battery is outside its
charging temperature range,
three LEDs will flash on the
battery level indicator.
Code:
If a fault is detected in the
battery, two LEDs flash on the
battery level indicator.
Code:
No LEDs will flash if the charger
is defective and will not charge.
One or more LEDs will light up
permanently, depending on the
battery level.
Code:
No LEDs will light up if there is
no power.
Table 42: List of battery error messages
Operation
Method of resolution
1
Disconnect charger from
battery.
2
Leave battery to cool down.
3
Contact your specialist
dealer if the problem
persists.
 Contact specialist
dealer.
 Contact specialist
dealer.
1
Check all plug connections.
2
Check contacts on the
battery for dirt. Clean the
contacts carefully if needed.
3
Contact your specialist
dealer if the problem
persists.
104

Advertisement

Table of Contents
loading

Table of Contents