Operation - Hyundai HNHP2065 Original Instructions Manual

Table of Contents

Advertisement

9. Connect the high-pressure hose to the
water outlet
Connect the other end of the
-
high-pressure hose to the water
outlet on the washer and twist the
black rotatable end-piece as
indicated to secure the connection.
10. Connect to water supply
Install the fitting (it must be screwed to
the water inlet). Then connect the water
supply hose to the water inlet of the
machine.
-
The minimum recommended length
for the water supply pipe is 10
meters (but not more than 25 meters)
with a diameter of 12.5 mm to avoid
back pressure and any potential
damage to your appliance. Make
sure it can withstand water and a
maximum pressure of 10bar
(0.1Mpa). If you want to connect
your device to other water sources,
make sure the maximum water inlet
pressure is 10bar (0.1Mpa).
Start up
Before starting
NOTE: Never operate the sprayer
without first opening the water supply!
Never open the sprayer cover during
operation. Do not use the sprayer in
hazardous environments and places
where explosive substances are stored
Do not put water in materials containing
asbestos and other materials
dangerous to health
Do not use liquids containing organic
solvents, acids or petroleum-based
solvents, paint or oil whose vapors are
highly flammable, explosive and toxic.
Acetone compounds, acid solvents are
corrosive and may damage the device.
Open the tap but do not start the
machine immediately.
• Turn the 0/1 switch button on the
position 1 to switch on the machine.
• If the yellow tab of the trigger is on
horizontal position, pull it in vertical to
unlock the lever of the trigger gun.
• Push the lever of the trigger gun, the
device will switch on.
• Let the device run (max. 2 minutes)
until the water exits the trigger gun
without bubbles.
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun by
pulling the yellow tab on horizontal
position.

Operation

ATTENTION
Dry running of more than 2 minutes
leads to damage of the high-pressure
pump. If the appliance does not build up
pressure within 2 minutes, switch the
appliance off and proceed in

Advertisement

Table of Contents
loading

Table of Contents