Pre-Operation Checks - Hyundai HYW3600DE2 User Manual

4. PRE-OPERATION CHECKS

Follow the checklist below before using the machine each time.
1. Check to ensure the engine oil is at the correct level. Use SAE 15W40 - API CH-4/CF/SJ/SL diesel
engine oil or higher grade.
2. Make sure that all connection, nuts/bolts etc are tight and will not vibrate loose.
3. Add fuel to the diesel tank - regular diesel fuel.
4. Connect and tighten the garden hose to the garden hose connector.
5. Water must be turned on prior to starting the washer. Always pull the spray trigger to prevent
pressure build up and ensure water is moving through the hoses and out of the nozzle
without any leaks before starting the unit.
5. Review the safety guidelines in the manual prior to starting the unit.
6. If you have any issues operating the pressure washer, contact your dealer.
• Failure to do so could cause the engine and pump to seize if the oil is low or empty.
Connect hose and water supply to pump before starting.
• Failure to do so will result in damaging the pump from overheating
and voiding the warranty.
Checking the engine oil level.
1. Turn the oil filler cap/dipstick anti-clockwise
and remove it from the oil filler tube, wipe the
dipstick with a clean cloth.
2. Insert the oil filler cap/dipstick back into the oil
filler tube and then remove it again. DO NOT
screw it in when doing this.
3. If the oil is low fill the engine oil sump to the edge
of the oil filler hole.
• We recommend the use of SAE30 - API CH-4/CF/SJ/SL
diesel engine oil or higher grade oil in this pressure
washer pump.
4. Replace the oil filler cap.
NOTE: Running the engine with
insufficient oil can cause engine damage.
Always check the level of the engine and pump oil prior to starting
the washer.
DO NOT start your pressure washer without the water
supply tumed on.
Page 8
Figure 7
Figure 8