Table of Contents
Advertisement
accordance with the instructions in
Chapter "Troubleshooting"
High pressure operation
CAUTION
Keep a distance of at least 30 cm when
using the jet for cleaning painted
surfaces to avoid damage.
CAUTION Make sure that the
machine is switched off (on position 0)
and insert the plug into a properly
installed socket.
ATTENTION
• The washer must be used on a secure
and stable surface in an upright
position.
• Turn on the switch "0/1" to the 1
position.
• Hold the spray gun with both hands.
Direct the water jet to the object to be
cleaned and press the trigger.
Release the lever of the trigger gun; the
device will switch off again and stop the
water jet. High pressure remains in the
system.
WARNING! Beware of kickback when
pressing the trigger!
Operation with detergent
Detergent can only be added when the
unit is used in low pressure mode.
DANGER
When using detergents, the material
data safety sheet issued by the
detergent manufacturer must be
adhered, especially the instructions
regarding personal protective
equipment.
Remove the cap of the clean detergent
bottle.
Fill the bottle with detergent designed
specifically for use with pressure
washers.
Put the cap on the bottle and close it.
Push firmly the bottle in the gun and
turn it clockwise to lock it in place.
To remove the detergent bottle, turn it
anticlockwise and pull it from the gun.
Recommended cleaning method
• Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
• Spray off loosened dirt with the high
pressure Met.
Interrupting operation
• Release the trigger gun lever.
• Lock the trigger gun lever by pulling
the yellow tab to the horizontal position.
• Place the trigger gun with the lance in
the park position.
• During longer breaks (more than 5
minutes), also set switch "0/1" to
position 0 to switch off the machine.
Finish operation
• Release the lever of the trigger gun.
• Turn the "0/1" switch to the position 0
to switch off the machine.
Advertisement
Table of Contents
