Disc Mode - Rayleigh Instruments RI-ENERGYFLOW-MODULAR Series Quick Start Installation Manual

Programming and menu
Menu Path: Setup > Enter Password (Default 00000) > SYS Setting:
Work Mode
PV input
SYS
Setting
Zero export
DRM Enable
EPS Enable
Remote CTRL
Start Delay
CEI SPI Ctrl
GFCICHK ENB

DISC MODE

Telephone : +44 (0) 1245 428500
Email : sales@rayleigh.com
Charge
from
Self
Grid:
Consume
Enable
Disable
Time
Setting
Peak SFT
Charge
DISCHG
BAT Priority
Independent
Independent
CV
Parallel
Disable
Enable
Disable
Enable
Disable
Enable
Disable
Enable
180s (when
20...300
set to UK)
Disable
Enable
Disable
Enable
Rated power
Rated power
Load priority
RI-ENERGYFLOW-MODULAR SERIES
The energy generated by the solar panels will be used in
the following order: Feed the home loads; Charge the
battery and then, feed into the grid. When the sun is not
Enable present, the load will be supported by the battery to
enhance self-consumption. If the power supply from the
batteries is not sufficient, the grid will support the load
This mode is designed for time-use mode. The customer
can set up the desired charging/discharging time &
power via the inverter screen or APP.
Disable
Manually forces the system to charge the batteries from
Manually forces the system to discharge to the
The battery is only used as a backup power supply when
the grid fails. As long as the grid works, the batteries
Disable won't be used to power the loads. The battery is charged
with the power generated by the PV system or from the
Allows the user to change the PV array configuration
(wiring changes would also apply!)
Allows the user to set the export to grid limit
Disable
If Enable is selected, the user will be prompted to enter
Only applicable in Austrailia and New Zealand at this
Disable
Enables the Backup output (the Load Switch needs to be
Disable
Disable Allows control via RS485 (Scada system for example)
This is the boot delay from when power is applied to the
This function is only applicable to use via DRM for
Disable remote control (Australian and New zealand markets
Enable Ground fault monitoring on the AC grid connection
Allows the user to select the mode of discharge. Rated
power means that the applied discharge power
percentage. Load priority mean that the system supplies
www.rayleigh.com
demand.
the grid
connected load
grid.
the power
time
turned ON).
inverter
only)
the full output to drive the load
| Continued
8