IBM Netfinity EXP300 Installation And User Manual page 27

Use clip nuts if your rack has holes. If your rack has square holes, you
Note:
can use the rack-insertion tool or a flat-blade screwdriver to install cage
nuts.
2. On the rail marked R, loosen the four screws 2 .
3. Hold the rail against the outside of the right rack-mounting flange, and loosely
insert the two front M6 screws 1 .
4. Extend the rail outside of the rear rack-mounting flange; then, install and tighten
two rear M6 screws 3 .
5. Tighten the two front screws 1 ; then, tighten the four screws 2 .
Repeat step 2 through step 5 to install the rail marked L on the left side of the rack.
Chapter 2. Installing the expansion unit
15