2.1
Installing the ServeRAID-MR10k SAS/SATA DIMM
2-2
This section describes the installation of the ServeRAID-MR10k DIMM
on the IBM System x3850 M2 and IBM System x3950 M2. The
ServeRAID-MR10k DIMM mounts in a DIMM socket on the motherboard.
The remote intelligent BBU is mounted in a bracket next to the DIMM.
Figure 2.1
displays the custom 240-pin DDR2 form factor that contains
the RAID key. The J1 connector on the back of the DIMM connects by
cable to the remote iTBBU.
Figure 2.1
DIMM Module
Figure 2.2
displays the remote intelligent transportable battery backup
unit that connects by cable to the DIMM module.
Figure 2.2
Remote Intelligent Transportable Battery Backup Unit
Installing a ServeRAID-MR10k SAS/SATA DIMM
J1 on back
of board
85023-00
85023-01