Table of Contents
Advertisement
vi
Note:
Use the ServeRAID-MR10k DIMM with UL-listed
Information Technology Equipment (ITE) products only.
When working on or around the system, observe the following precautions:
Electrical voltage and current from power, telephone, and communication cables
are hazardous. To avoid a shock hazard:
•
Connect power to this unit only with the provided power cord. Do not use the
provided power cord for any other product.
•
Do not open or service any power supply assembly.
•
Do not connect or disconnect any cables or perform installation, maintenance,
or reconfiguration of this product during an electrical storm.
•
The product might be equipped with multiple power cords. To remove all
hazardous voltages, disconnect all power cords.
•
Connect all power cords to a properly wired and grounded electrical outlet.
Ensure that the outlet supplies proper voltage and phase rotation according to
the system rating plate.
•
Connect any equipment that will be attached to this product to properly wired
outlets.
•
When possible, use one hand only to connect or disconnect signal cables.
•
Never turn on any equipment when there is evidence of fire, water, or structural
damage.
•
Disconnect the attached power cords, telecommunications systems, networks,
and modems before you open the device covers, unless instructed otherwise
in the installation and configuration procedures.
•
Connect and disconnect cables as described in the following procedures when
installing, moving, or opening covers on this product or attached devices.
To disconnect:
1.
Turn off everything (unless instructed otherwise).
2.
Remove the power cords from the outlets.
3.
Remove the signal cables from the connectors.
4.
Remove all cables from the devices.
To connect:
1.
Turn off everything (unless instructed otherwise).
2.
Attach all cables to the devices.
3.
Attach the signal cables to the connectors.
4.
Attach the power cords to the outlets.
5.
Turn on the devices.
(D005)
Preface
DANGER
Advertisement
Table of Contents
