Table of Contents
Advertisement
Step 6. Touch the static-protective package that contains the DIMM to
any unpainted metal surface on the outside of the server; then,
remove the DIMM from the package.
Step 7. Turn the DIMM so that the keys align correctly with the slot.
Step 8. Insert the DIMM into the connector by aligning the edges of the
DIMM with the slots at the ends of the connector.
Attention:
Incomplete insertion might cause damage to the server or
the DIMM.
Step 9. Firmly press the DIMM straight down into the connector by
applying pressure on both ends simultaneously.
The retaining clips snap into the locked position when the
DIMM is seated in the connector.
Step 10. Install the battery in the divider that contains the battery holder.
Step 11. Install the divider that contains the battery holder in the server.
Step 12. Route the battery cable through the cable routing guides on the
divider to the DIMM.
Step 13. Insert the battery cable connector into the J1 connector on the
backside of the DIMM.
Installing the ServeRAID-MR10k SAS/SATA DIMM
2-5
Advertisement
Table of Contents
