NordicTrack VR User Manual page 6

1.
To make assembly easier, read the tips on
page 5 before you begin assembling the
exercise cycle.
Orient the Front Stabilizer (15) with the Wheels (17)
in the position shown.
Attach the Front Stabilizer (15) to the Frame (1) with
two M10 x 96mm Button Bolts (65) and two M10
Locknuts (91) (only one is shown).
2. While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (16) to the Frame with
two M10 x 96mm Button Bolts (65) and two M10
Locknuts (91).
3. Tip: Loosen the four M6 x 38mm Button Screws
(25) if the Backrest Tubes (52) do not slide into
the Seat Carriage (41).
Insert the Backrest Tubes (52) into the Seat
Carriage (41).
Attach each Backrest Tube (52) with an M8 x 35mm
Button Bolt (72), an M8 Split Washer (93), and an
M8 Locknut (99). Make sure that the Locknuts
are in the hexagonal holes in the Seat Carriage.
Do not tighten the Button Bolts yet.
All manuals and user guides at all-guides.com
6
1
1
91
2
91
65
3
25
52
99
93
72
93
72
17
65
17
15
91
1
16
25
52
41
99