Reversing The Door - Thermo Scientific ES Series User Manual

Reversing the Door

To reverse the door please follow the instructions below.
This procedure should be carried out by 2 people for safety
purposes.
Ensure cabinet is secure when tilted back before starting
the procedure. At all times the door must be stable so in
doesn't slip or fall over causing injury.
Tilt the freezer backwards by 45° and lean on a vertical, hard surface such as a wall
1.
Open door and remove the plastic foot plate (Figure 10)
2.
Remove the screws from the bottom hinge (Figure 11)
3.
Pull the door from the bottom to remove from the freezer
4.
5. Remove screws from hinge on bottom of door (Figure 12)
Remove bracket and hinge (Figure 13)
6.
Rotate hinge and fit to bracket (Figure 14)
7.
Refit hinge to LH side of door (Figure 15)
8.
Refit screws bottom RH side (Figure 16)
9.
Fig 12. Bottom of the door
Fig 15. Rotate and fit hinge
ES Series Lab Freezer
(232L Models Only)
Fig 10. Plastic Foot Plate
Fig 13. Remove bracket and hinge
Fig 16. Hinge LH side of door
Fig 11. Bottom Hinge
Fig 14. Remove hinge
Fig 17. RH side of cabinet
20