Table of Contents
Advertisement
Operation Modes
Operation mode
Power on
Screen off
Standby
See
page 38
for the power consumption in each mode.
*1: The sensor function is disabled when the monitor is in standard mode.
Switching of the operation modes (when in the WCD mode)
The operation modes switch as shown below.
1 Standby g Power on
- Press the
button on the monitor or the remote control in standby mode.
2 Power on g Standby
- Press the
button on the remote control.*
- Hold down the
button on the monitor for 2 seconds or more.*
3 Power on g Screen off
- There is no video signal, and the presence sensor does not detect anyone.*
- Press the
button on the remote control.
- Press the
button on the monitor.
4 Screen off g Power on
- A video signal is active or the presence sensor detects a person.
- Press the
button on the remote control.
- Press the
button on the monitor.
- Touch the screen.
5 Screen off g Standby*
- Press the
button on the remote control.
- Hold down the
button on the monitor for 2 seconds or more.
*2: A confirmation message is displayed, and switching to the standby mode can be canceled.
*3: When no video signal is input for the set time (see
*4: Switches to the standby mode about 10 seconds after the operation.
NOTE:
If the standard mode is set (see
on state.
Status
All functions can be used.
The same as with power on, but the screen is turned off. The sensor function is enabled.*
The screen is turned off, and the sensors are disabled. The power consumption is reduced.
Standby
2
4
page
29) and the presence sensor does not detect anyone for 30 seconds or more.
page
30), the monitor switches to standby if no video signal is input in the power
Power on
1
3
4
2
Screen off
5
2
*
3
4
English-26
1
Advertisement
Table of Contents
