Table of Contents
Advertisement
OSD Settings
Advanced Setting
Menu
Function
Data & Time
Network Time
Data
Time
Time Zone
Customer NTP Server Optionally configure this setting to synchronize with an NTP server on the network to set
NETWORK*
DHCP
1
IP Address
Subnet Mask
Default Gateway
Auto DNS
DNS
MAC Address
Apply
Power
Auto Power ON
AUTO STANDBY
Cloud Settings*
Cloud Service
2
Telemetry data
transmission interval
Set the time manually.
Get time automatically from network.
Set the year, month, and day. (YYYY, MM, DD)
Set the current time.
Select the local time zone to use the monitor.
the current date and time. It can be set by IP address or host name.
Configure the network settings manually. Contact the Network Administrator for
this information.
The IP address is automatically obtained from the DHCP server.
Set the IP address for the monitor connected to the network when
[DHCP].
Set the subnet mask data for the monitor connected to the network when
selected for [DHCP].
Set the default gateway for the monitor connected to the network when
for [DHCP].
Manually enter the IP address of the DNS server which is connected to the
monitor.
The DNS server which is connected to the monitor will automatically assign its
IP address.
Enter the DNS server settings of the network connected to the monitor.
Shows the monitor's [MAC Address].
Apply the network settings.
Signal Detected
The monitor does not automatically turn on when a signal
is input.
The monitor turns on automatically when a signal is input.
Presence Sensor
The monitor does not turn on automatically even if a
person is detected by the motion sensor.
The monitor automatically turns on when a person is
detected by the motion sensor.
Off
Maintain Power ON state.
5, 15, 30 Minutes
If there is no signal for the set time, the device shifts to the Screen
off*.
* In WCD Mode. It shifts to the standby status in Standard Mode.
Enable
Enables the cloud connection and transmits telemetry data.
Telemetry data is the sensor environment data described on
page
10.
Disable
Disables the cloud connection.
Sets the time between telemetry data transmission to your servers. The interval can be
set between 10 to 120 minutes in 10-minute increments.
English-29
is selected for
is
is selected
Advertisement
Table of Contents
