Lorex L20WD800 Series Network Setup Manual page 5

Setting up remote viewing on the l20wd800 series combo dvr/monitor system

Hide thumbs Also See for L20WD800 Series:

Table of Contents

System - IP & MAC Address

The IP & MAC Addresses are necessary for DDNS

Setup (for remote access to the System).

To Locate the System information, Press the

ENTER button on the Front Panel or

Info on the Remote Control while viewing the

Cameras. The System Info window will be

displayed.

- OR -

1. Press the Menu Button on the Front Panel or Remote Control,

or right click with the mouse to access the Setup Menu. Select

the System Setup option and press the Enter button.

2. Navigate to the System Menu option.

Press the Enter button to access the System Menu.

3. Navigate to the System Management menu, and press the

Enter Button to access the settings.

4. Select the System Information option, and press the Enter

Button to display the System Settings.

NOTE: Your IP address should look similar to 192.168.0.105, 10.0.0.105, etc. If your IP

address is appearing as 127.0.0.1, please review all menu settings, and check to make

sure that your Ethernet cable is properly connected to your Router and System.

System - IP & MAC Address

Table of Contents