COMPX Pearl KEYPAD Installation Instructions Manual page 9

KEYPAD version
Pearl
– installation instructions
Electronic push button cabinet lock
Reset User Code to Factory Default 1234
To reset the User Code to the factory
default 1234 follow the steps on page
5 to enter programming mode.
There is a 10 second programming time
limit between each step. If Pearl times
out or error is made, programming
will end and you will need to enter
programming mode again.
Add User Without Specifying Memory Slot
The Supervisor Code memory location
is called Slot 01 and the first User
Code is called Slot 02.
Any additional User Codes reside in
memory slots 03-20.
To add a user code without specifying a
memory slot (03 -20), follow the steps
on page 5 to enter programming mode.
User codes must be 4 to 8 digits in
length and must be different from
all existing codes (including Slot 01
Supervisor & Slot 02 User codes).
There is a 10 second programming time
limit between each step. If Pearl times
out or an error is made, programming
will end and you will need to enter
programming mode again.
Pearl — Installation instructions: KEYPAD version
(Does not apply to Single Use Mode)
1. Place Pearl into programming
mode (see page 5).
2. Type 8888 and then press the
(enter) button.
3. If successful, the green indicator
light will illuminate for 1 second.
Continue programming or press 9 and
then (enter) to exit programming.
1. Place Pearl into programming
mode (see page 5).
2. Press 410 and then press
(enter).
3. Type the new user code and
press (enter)
4. Retype the new user code and
press (enter).
5. If successful, the yellow indicator
light will illuminate.
Continue programming or press 9 and
then (enter) to exit programming.
9