Juniper SRX5600 Installing page 2

Installing the SRX5600 Services Gateway Fan Tray
2
Installing the SRX5600 Services Gateway Fan Tray
Figure 1: Removing the Fan Tray
To install the fan tray (see Figure 2):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the strap to one of the ESD points on the chassis.
Grasp the fan tray handle and insert it straight into the chassis. Note the correct
2.
orientation by the this side up label on the top surface of the fan tray.
Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
3.