Advertisement
Step 1:
Remove the Windshield to enable access for fitting the Mounting Bracket (1).
From inside of the Acrylic mount, Insert Washer M6 (6) – 2 off, Screw M6 x 15 (7) – 2 off, through the mounting
holes, as shown above, and Orient and align the Mounting Bracket (1), in-line from the Front side and slip-in the
Nut M6 (8) – 2 off and secure the threads and tighten it to torque, as specified in the BOM table.
Step 2:
The Bottom Bracket (5), is intended to
support the Acrylic Front mount, Stability
and Balance of weight.
Remove the 4 off Mounting Screws
(Original) and Orient and Align the Bottom
Bracket (5) and secure the threads in the 4
mounting points.
Copyright By SRC
Design and Specification are subjected to change
Mounting Instructions
Page 3
Advertisement
