Page 1
9 - 10 Middle Plate Nut M6 SRC Design uses Met ric System of Measu reme nt and all dimensions in Millimeters * Recommended to use the Torque specified in the table **Deno tes Usage of Liquid Thread Locker in specified Locations...
MOUNTING DRAWINGS Copyright By SRC Design and Specification are subjected to change Page 2...
Page 3
Motorbike firmly rest on the floor, using the Centre Stand. The side stand can be brought forward (position as shown in the drawing) to have access to the Mounting/ Assembly of the SRC Large Side Stand. Step 2: Orient and slip-in the Upper Plate (2), through the Open cut-out and pass the shank of the Side-stand, as shown.
Page 4
The Countersunk screws to flush into the countersunk bores of the Lower Plate. Slip-in the Nut M6 (7) – 4 off from the top side and secure the threads on the Countersunk screws. Copyright By SRC Design and Specification are subjected to change Page 4...
Page 5
Fully tighten the Nut M6 to torque as per specification in the BOM table. The final mounted condition of the Large Side Stand will be as shown in the drawing above. Copyright By SRC Design and Specification are subjected to change Page 5...
Vehicle. It is always advised to check loosening of the fasteners after the first 50 kilo meters of ride and at regular intervals. 7. We are showing here the Scope of Supply/ Installation/Parts list & BOM from SRC 8. To the maximum extent possible, our design use the current Mounting/Fitment of the...