1.Selecting the position
2.Insert the test leads into the jacks, the red plug into
jack and black plug into COM jack.
3.Connect the test leads to the circuit under test.
4.The resistance value is displayed and the
instrument emits a sound signal if the resistance
value results to be lower than 140Ω.
5.The message "O.L." on the display indicates that
the resistance value is higher than 400.
The displayed value is just indicative and
does not correspond to the resistance value.
4.3.7. Diode test
Before taking resistance measurements on
the circuit remove power from the circuit
being tested and discharge all capacitors.
.
CAUTION
CAUTION
EN - 21
TM-86