Table of Contents
Advertisement
2. WARNINGS AND SAFETY
Handling guidelines:
The unit must be handled with care in order to avoid damage to the unit's interior and exterior parts.
The unit might have sharp edges; use gloves during installation/adjustment.
All the operations listed below must be carried out in accordance with local health and safety regula-
tions.
Storage conditions:
Up to four packaged units may be stacked on top of each other. All units must be stored in a dry area.
Technical spaces and positioning:
Incorrect installation of the unit may cause noise and vibrations issues.
3. PACKAGING AND COMPONENTS
Follow these instructions when removing the packaging:
– check for any visible damage
– open the packaging
– check if the manual is in the package
– remove the packaging material and put it in the appropriate collection point or recycling facility, in
compliance with the local regulations.
Dispose of the packaging materials in compliance with the national or local regulations.
Do not leave the packaging within reach of children.
4. INSTALLATION
– installation must be carried out by certified technicians. Incorrect installation could cause product
failure, a reduced performance or an increased noise level.
– the unit must be installed in accordance with the local building codes.
– Always use personal protective equipment.
– the unit must remain accessible for inspection and maintenance, the trench must be removable at
all times.
4.1. ACOUSTIC INSULATION
Sound absorption
Sound is reflected by hard materials. Soft, porous materials are best suited for sound absorption. A
combination of different materials can reduce the reflection of sound.
Contact noise insulation
Sound travels very easily through hard materials. Soft rubber material can be used to reduce contact
noise. The effect of this insulation strongly depends on:
– installation method: make sure that vibrations cannot be transferred between different elements,
e.g. between the built-in heaters and other metallic parts, through pipes, along air ducts etc.
– installation of acoustic insulation in hollow acoustic spaces. Avoid cavities between insulation and
pipes.
4
JAGA CANADA | BRIZA 26 | MANUEL | 2022.09.27 | V.01
Advertisement
Table of Contents
