Initial Start; Maintenance; Special Note; Routine Maintenance - Jaga BRIZA 26 Manual

Hide thumbs Also See for BRIZA 26:
Table of Contents

Advertisement

9. INITIAL START
IMPORTANT!
Start-up and Commissioning of the fancoil must be carried out by skilled staff, qualified to work on
this type of product.
DANGER!
Before start-up, make sure the installation has been carried out in compliance with in this manual.
Before start-up the fancoil unit, check if:
1. the unit is positioned correctly
2. the supply and return pipes are properly connected and insulated
3. the pipes are clean and air is removed
4. the inclination of the unit towards the drain and the p-trap are correct
5. the coils are clean
6. the wiring connections are correct and properly tightened
7. the supply voltage is correct
8. the electric power consumption is correct and does not exceed the maximum value indicated in
the catalog
10. MAINTENANCE
DANGER!
–  maintenance must be carried out by qualified technicians.
–  do not insert sharp objects into the supply and return grilles
the unit has sharp edges; use gloves during maintenance!
DANGER!
Always use the main disconnect switch to isolate the unit from the mains before carrying out any
maintenance or inspection work. Make sure that no one accidentally turns on the power to the unit;
lock the master switch in the off position.
10.1. SPECIAL NOTE
Maintenance and cleaning of the stainless steel protection grille:
a dirty grille obstructs the air flow, so clean the grille at regular intervals, depending on the room's
purpose and how it's used. The grille should never be disassembled for maintenance and can be
easily cleaned by using a vacuum cleaner.
Cleaning the unit:
always disconnect the power supply before servicing the fan!!
–  cleaning at regular intervals is important, depending on the room's purpose and how it's used
–  clean with a vacuum cleaner or air compressor. Do not use solvent- or detergent based products.
10.2. ROUTINE MAINTENANCE
Every 6 months: Check the condition of the coil and condensate drain:
If necessary:
–  remove any dirt from the coil surface
–  remove dust using an air compressor
–  wash with water and brush gently
–  dry by using compressed air
–  keep the condensate drain free from any obstructions that may prevent normal water flow
JAGA CANADA | BRIZA 26 | MANUEL | 2022.09.27 | V.01
EN
19

Advertisement

Table of Contents
loading

Table of Contents