Table of Contents
Advertisement
03
Connect the device to the hydraulic system by using the specified inlet/ outlet connections. Make sure that the connections are
air tight, use a sealant for this. The coil is equipped with a de-aerater.
If the unit is used for cooling, the hydraulic pipes must be insulated.
When using devices for cooling: iron couplings prohibited.
04
Connect the condensate pump.
05
Connect the device electrically.
18
IN
OUT
JAGA CANADA | BRIZA 26 | MANUEL | 2022.09.27 | V.01
Use a back-off wrench when faste-
ning the hydronic connections !
Remove black plug at hydraulic
connection.
N
L
GND
0-10V
120V / 60Hz
Speed control input
NOT USED
Advertisement
Table of Contents
