Table of Contents
Advertisement
8.3.2. Hydraulic & electrical connection
19 ⁴⁹/₆₄
12 ²¹/₆₄
8.4. INSTALLATION
01
Mark and drill the mounting holes for the the device.
The type of wall determines which type of screw or plug must
be used.
Make sure that the wall is level and has sufficient loadbearing
capacity!
JAGA CANADA | BRIZA 26 | MANUEL | 2022.09.27 | V.01
2 ¹⁹/₃₂
7 ⁷/₁₆
N
L
GND
0-10V
120V / 60Hz
Speed control input
1. Place the screws of the device(5-8) and let them stick out 1
2. Place the device in the correct position.
3. Tighten the screws. [2]
Threaded rods: mount the unit on the threaded rods. Use a
washer between screw head and the appliance.
5 ¹⁹/₃₂
9 ¹/₁₆
10 ¹⁵/₆₄
11 ⁵⁷/₆₄
NOT USED
02
cm. Use a washer between screw head and the appliance. [1]
The installer should provide sound dampening material.
0²⁵/₃₂
Stop hydraulic
connection during
assembly
Dimensions in Inches
1
2
EN
17
Advertisement
Table of Contents
