Hardware Setup; Analog Connections - Linear Technology QuikEval DC1718A Manual

harDware set-up
CONNECTION TO DC590 SERIAL CONTROLLER
J1 is the power and digital interface connector. Connect
to DC590 serial controller with supplied 14 conductor
ribbon cable.

ANALOG CONNECTIONS

Analog signal connections are made via the row of turret
posts along the edge of the board. Also, when connecting
the board to an existing circuit the exposed ground planes
along the edges of the board may be used to form a solid
connection between grounds.
DEMO MANUAL DC1718A
GND – This turret is connected directly to the internal
ground planes.
V – This is the supply and reference voltage for the ADC.
CC
Do not draw any power from this point.
IN – This is the positive input to the ADC
REFOUT – This turret is connected to the LTC2471 REFOUT
pin. This pin may be used to provide a reference voltage
to an external circuit and can source up to 100µA. Do
NOT drive this pin.
dc1718afb
3