Advertisement
Mid-panel connectors are used to secure the middle of the
panels.
When you remove the front door, remember the orientation, i.e., which part of the
door is the inside and outside. You'll want to attach the door the same way it was
taped. The laser cuts at a slight angle, so if you insert the door backward this can
create interference making it difficult for the door to swing correctly.
The front should look like the picture to the right.
Note again that the connectors are on the inside of
the enclosure.
2. Assemble Front Door
Locate the magnetic latches and use the wood screws to
attach them to the latch mounts. Hand tighten and make
sure they're secure, but do not over tighten, or they may
strip. The latch can be later adjusted front-to-back to ensure
the door is flush with the door frame.
Each latch mount is attached via three screws. Two M4
12mm cap heads attach the latch mount to the side, while
a 30mm cap head secures the latch mount to the door
frame.
Attach the door and door frame hinges using M4 12mm
screws and nuts. There will be some play in the hole size so
that you can adjust the door to swing freely.
Copyright 2022 3DUpfitters
9
Advertisement
