Advertisement
Attach the doorknob by first inserting the square M4 nut into
the slot. Use a 16mm cap head screw to attach the door.
Now that the latches are mounted, it is time to connect the
strike plates. Each plate comes with a squishy adhesive
covering the exact size of the plate. Carefully attach the
adhesive side to the acrylic at the location of each latch.
Then, adjust the width of the metal strike plate so that it is
held on by the pressure of the two sides of the plate. The
adhesive covering will keep the metal strike plate from
scratching the acrylic.
Pro Tip!
You can more easily adjust the front door to swing freely and fit perfectly by first
placing the front on its side so that the hinges are at the top. Next, loosen the hinge
screws and use the strike plates to hold the door in place. Try to position the inside
door to equal the gap on all sides, and then tighten the hinge screws.
3. Attach Left Side
Attach the left side to the front forming an L-shape that
will stand up on its own, then attach one L and one R
connector at the back. The CR-10 Smart design adds a
side door for easy access to the extruder.
The latch mounts are smaller than the front, although
the magnetic latch attaches in the same way with wood
screws. The parts for the side door will be in a separate
packet.
Attach the door hinges, latch mounts, strike plates, and
Copyright 2022 3DUpfitters
10
Advertisement
