Advertisement
1. Situate the display so that the three prongs
fit inside the three holes and wiggle the
display until it is flush against the mount.
2. Slide the display down along a fraction of a
mm to seat the prongs into place.
8. Attach Front Tray
The front tray exists to give the fans inside the printer a source of cool air. With the fan
in the back running, this gives a clear path to bring air into the enclosure, cooling the
electronics, and then out the back.
Just slide in the tray from the outside and use the M4 12mm screws to attach it to the
front. The lid fits into place, covering the gap between the printer and the front of the
enclosure.
Copyright 2022 3DUpfitters
18
Advertisement
