Advertisement
Assemble Panels
1. Attach The Front Door Frame Corners
Each of the corners of the enclosure will be held together by the connectors pictured
below. There are only two versions, L and R, which can be identified by the letters
stamped on the inside. The opposite connectors are identical, i.e., Bottom Right is the
same as Top Left. In all cases, the surface of the connector with the cutout pattern
faces front or back.
The front door is designed so that the latches are on the right when viewed outside.
Attach the corner connectors on the backside of the door frame using the provided
cap head M4 12mm screws. See the photos below. The top of the connector should
be flush with the acrylic top.
Top Left
Bottom Left
View from the back of the front panel
View from the front of the front panel
Copyright 2022 3DUpfitters
Top Right
Bottom Right
8
Advertisement
