Advertisement
9. Sealing Gaps
Once the enclosure is completely put together, it is time to make sure that each panel
is held tightly to each adjoining panel. The connectors are designed with a small
amount of play that allows you to make minor adjustments for the perfect fit.
1. Loosen screws on the panel to move.
2. Push that panel into place. You may need a friend to hold it tightly in the right spot.
3. Re-tighten the screws to hold the panel. Only tighten enough to hold the pieces
snuggly. DO NOT OVER-TIGHTEN! These parts are sturdy, but they're still all made of
plastic.
Repeat the product, going around the enclosure, looking to make sure all panels are
flush with each other.
10. Filament
The CR-10 Smart Pro printer is a direct drive and feeds filament through a slit in the
top. You can use any spool holder you want or purchase one of our acrylic spool
holders to match the look of the enclosure.
Copyright 2022 3DUpfitters
19
Advertisement
