Advertisement
5. Attach the Right Side
The right side is a simple, plain sheet of
acrylic. Note that there is a hole at the top for
the mid-panel connector and a slot at the top
for the support beam installed in the next
step.
6. Attach Top
In general, you are not going to want to place
anything heavy on top of the enclosure, as over
time, it might sag with repeated heating and
cooling cycles. We've used it to hold a 1Kg roll of
filament and had no long-term problems.
But before you can attach the top, you need to slip
the support beam into the slots on the left and right
sides.
Copyright 2022 3DUpfitters
13
Advertisement
