Axis ExCam XF Q1645 User Manual page 14

ExCam XF Q1645 Explosion-Protected Network Camera
Configure your device
4. In the list of actions, under Recordings, select Record video.
5. In the list of storage options, select SD_DISK.
6. Select the stream profile where audio has been turned on.
7. Set the prebuffer time to 5 seconds.
8. Set the postbuffer time to 2 minutes.
9. Click Save.
Record video when the camera detects impact
Shock detection allows the camera to detect tampering caused by vibrations or shock. Vibrations due to the environment or to an
object can trigger an action depending on the shock sensitivity range, which can be set from 0 to 100. In this scenario, someone is
throwing rocks at the camera after hours and you would like to get a video clip of the event.
Turn on shock detection:
1. Go to System > Detectors > Shock detection.
2. Turn on shock detection, and set a value for the shock sensitivity.
Create a rule:
3. Go to System > Events > Rules and add a rule.
4. Type a name for the rule.
5. In the list of conditions, under Device status, select Shock detected.
6. Click + to add a second condition.
7. In the list of conditions, under Scheduled and recurring, select Scheduled event.
8. In the list of schedules, select After hours .
9. In the list of actions, under Recordings, select Record video while the rule is active.
10. Select where to save the recordings.
11. Select a Camera.
12. Set the prebuffer time to 5 seconds.
13. Set the postbuffer time to 60 seconds.
14. Click Save.
Send an email automatically if someone spray paints the lens
Activate the tampering detection:
1. Go to System > Detectors > Camera tampering.
2. Set a duration for Trigger after. The value indicates the time that must pass before an email is sent.
3. Turn on Trigger on dark images to detect if the lens is sprayed, covered, or rendered severely out of focus.
Add an email recipient:
4. Go to System > Events > Recipients and add a recipient.
5. Type a name for the recipient.
14