Axis ExCam XF Q1645 User Manual page 13

ExCam XF Q1645 Explosion-Protected Network Camera
Configure your device
2. Type a name for the rule.
3. In the list of actions, under Overlay text, select Use overlay text.
4. Select a video channel.
5. In Text, type "Motion detected".
6. Set the duration.
7. Click Save.
Record video when the camera detects an object
This example explains how to set up the camera to start recording to the SD card five seconds before it detects an object and to
stop one minute after.
1. Start the application if it is not already running.
2. Make sure you have set up the application according to your needs.
Create a rule:
1. Go to System > Events and add a rule.
2. Type a name for the rule.
3. In the list of actions, under Recordings, select Record video while the rule is active.
4. In the list of storage options, select SD_DISK.
5. Select a camera and a stream profile.
6. Set the prebuffer time to 5 seconds.
7. Set the postbuffer time to 1 minute.
8. Click Save.
Record video when the camera detects loud noises
This example explains how to set up the camera to start recording to the SD card five seconds before it detects loud noise and
to stop two minutes after.
Note
The following instructions require that a microphone is connected to audio-in.
Turn on audio:
1. Set up the stream profile to include audio, see Add audio to your recording on page 15.
Turn on audio detection:
1. Go to System > Detectors > Audio detection.
2. Adjust the sound level according to your needs.
Create a rule:
1. Go to System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, under Audio, select Audio Detection.
13