Set Default Parameter; Beeper Tone; Laser On Time - Logic Controls LK7000 Programming Manual

Klaser series programmable keyboard built-in laser barcode scanner

Hide thumbs Also See for LK7000:

Table of Contents

Set Default Parameter

Scanning this barcode returns all parameters to the factory default values.

To select a decode beep frequency (tone), scan the appropriate bar code.

This parameter sets the maximum time decode processing continues during a scan attempt. It is

programmable in 0.1 second increments from 0.5 to 9.9 seconds. To set a Laser On Time, scan the barcode

below. Next scan two numeric barcodes at end of this manual that correspond to the desired on time. Times

less than 1.0 second must have a leading zero. For example, to set an on time of 0.5 seconds, scan the bar

code below, then scan the "0" and "5" bar codes. If you make an error, or wish to change your selection,

scan the CANCEL barcode.

Table of Contents

Do you have a question about the LK7000 and is the answer not in the manual?