Operational Parameters - Logic Controls LK7000 Programming Manual

Operational Parameters

The Klaser integrated barcode scanner is shipped with the default settings shown below. These
default values are stored in non-volatile memory and are preserved even when the scanner is
powered down.
You can change the default values by scanning the appropriate bar codes included in this manual.
These new values replace the standard default values in memory. The default parameter values
can be recalled by scanning the SET ALL DEFAULTS bar code.
Parameter
Beeper Tone
Laser On Time
Triggering Mode
Time-out Between Same Symbol
Beep After Good Decode
UPC-A
UPC-E
UPC-E1
EAN-8
EAN-13
Bookland EAN
Decode UPC/EAN Supplementals
Transmit UPC-A Check Digit
Transmit UPC-E Check Digit
Transmit UPC-E1 Check Digit
UPC-A Preamble
UPC-E Preamble
UPC-E1 Preamble
USS-128
UCC/EAN-128
ISBT 128
Code 39
Set Length(s) for Code 39
Code 39 Check Digit Verification
Transmit Code 39 Check Digit
Code 93
Set Length(s) for Code 93
Interleaved 2 of 5
Set Length(s) for I 2 of 5
I 2 of 5 Check Digit Verification
Transmit I 2 of 5 Check Digit
Discrete 2 of 5
Set Length(s) for D 2 of 5
Codabar
NOTIS Editing for Codabar
Set Lengths for Codabar
Prefix
Suffix 1
Suffix 2
Scan Data Transmission Format
Default Value
Medium Frequency
3.0 sec
Level
1.0 sec
Enable
Enable
Enable
Disable
Enable
Enable
Disable
Ignore
Enable
Enable
Enable
System Character
System Character
System Character
Enable
Enable
Enable
Enable
2-55
Disable
Disable
Disable
4-55
Enable
14
Disable
Disable
Disable
12
Disable
Disable
5-55
NULL
LF
CR
Data as is
1