Enable/Disable Codabar; Set Lengths For Codabar - Logic Controls LK7000 Programming Manual

Klaser series programmable keyboard built-in laser barcode scanner

Hide thumbs Also See for LK7000:

Table of Contents

Codabar

Enable/Disable Codabar

Lengths for Codabar may be set for one discrete length or lengths within a specific range. The

length of a code refers to the number of characters (i.e., human readable characters) the code

contains, and includes check digits. (Numeric barcodes are at the end of this manual. If you make

an error, or wish to change your selection, scan the CANCEL barcode. Single digit numbers must

always be preceded by a leading zero.)

One Discrete Length

- This option allows you to decode only those codes containing a selected length. For example, if

you scan Codabar One Discrete Length and then scan 1, 4, then the only Codabar symbols

decoded are those containing 14 characters.

Length Within Range

- This option allows you to decode a code type within a specified range. For example, to decode

Codabar symbols containing between 7 and 12 characters, first scan Codabar Length Within

Range. Then scan 0, 7, 1 and 2.

Table of Contents

Do you have a question about the LK7000 and is the answer not in the manual?