Logic Controls LK7000 Programming Manual page 12

Klaser series programmable keyboard built-in laser barcode scanner

Hide thumbs Also See for LK7000:

Table of Contents

Code 93

Enable/Disable Code 93

Set Lengths for Code 93

Lengths for Code 39 may be set for one discrete length or lengths within a specific range. The length of a

code refers to the number of characters (i.e., human readable characters), including check digit(s) the code

(Numeric barcodes are at the end of this manual. If you make an error, or wish to change

contains.

your selection, scan the CANCEL barcode. Single digit numbers must always be preceded by a

leading zero.)

One Discrete Length

- This option allows you to decode only those codes containing a selected length. For example, if

you scan Code 39 One Discrete Length and then scan 0, 9, only Code 93 symbols containing

9 characters are decoded.

Length Within Range

- This option allows you to decode a code type within a specified range. For example, to decode

Code 93 symbols containing between 4 and 12 characters, first scan Code 93 Length Within

Range. Then scan 0, 4, 1 and 2.

Table of Contents

Need help?

Do you have a question about the LK7000 and is the answer not in the manual?